Free Shipping On Orders Over $1500. Limited Time Only.

Realstone Systems Casa Di Sassi Volterra Turin Corners

Tile and stone products are fragile, and it is normal to have some broken pieces during transit. You may receive up to 5% broken pieces. Please figure this potential breakage into your waste calculation.

Coverage Calculator

18.0 Sq. Ft. Minimum

 Sq. Ft.

 Carton

$11.39

/Sq. Ft.


$91.12

/Carton

Free Shipping On Orders over $1,500 Over 2,000 Sq. Ft., you may qualify for a volume discount.
Please contact us.

Total Price: 



Casa di Sassi Volterra Stone Veneer Corners – Turin

These are the corner pieces made to match Casa di Sassi's Volterra stone veneer in Turin. Each piece is L-shaped with two finished faces, one long and one short, so it wraps an outside corner and shows stone texture on both walls. Without corners, outside edges show the cut back and side of a flat, which gives the wall away as veneer.

Use corners anywhere the stone turns an outside corner or ends at an exposed edge: building corners, columns, fireplace sides, bar fronts, window and door returns, and wainscots that stop mid-wall. Inside corners don't need them, because flats butt together there. Alternate the long and short legs from course to course so the corner looks like laid stone.

Turin has the most color range in the Volterra line, with charcoal, ash, greige, brown, and taupe mixed together. The corners carry that same variation. Because a corner is visible from two directions, blend the darker and lighter pieces as you go up the wall. The corners are cast in the same color and texture as the Volterra Turin flats and made in the USA from Portland cement, lightweight aggregates, and mineral oxide pigments.

Buy them with Volterra Turin flats, and order both at the same time so they come from the same production run and match in color.

 

Spec Detail
Brand Casa di Sassi
Profile Volterra
Color Turin (charcoal, ash, greige, brown, taupe)
Piece Type Corners
Material Manufactured stone veneer 
Piece Size 11" × 4"–17-1/2" (varies)
Avg. Thickness 2.75"
Grout Joint 1/2"
Coverage 8 Sq. Ft. per carton
Application Interior and exterior outside corners and exposed ends
Pairs With Volterra Turin Flats (sold separately)
Warranty 50-year limited

 

How do I keep dark pieces from stacking up on a corner?
Lay out a full corner run on the floor before you set it. Swap pieces around until no two charcoal or dark brown stones sit on top of each other, then install in that order.

Does a freestanding bar or kitchen island need corners?
Yes, on every outside edge where the stone wraps from one face to the next. Turin's darker tones also hide scuffs from barstools and feet, which suits a bar front.

Can corners be used at the end of a stone accent wall?
Yes. When an accent wall stops before the room's corner, a column of corner pieces finishes the exposed end. Without them, you'd see the side of every flat.

Are corners harder to set than flats?
Slightly. They have two faces to keep plumb. Use a level on both faces of the first few courses, then check every few courses after that.

What if my corner isn't a true 90 degrees?
Small variations can be absorbed in the mortar joint. For angles well off 90 degrees, like a bay window, cut and fit flats instead, and finish the cut edges with mortar.

 

Sku: RS-TRVF-CDS-8