Get Inspired

Cupping in Hardwood Floors

Cupping is an environmental issue where the edges are higher than the center. The edges swell due to humidity, moisture or water. It can happen on both solid and engineered but is more likely to happen on solid. Depending on the severity it can be reserved with a dehumidifier.

End Cap

An end cap will transition from two surfaces that are not the same height, such as laminate to carpet. The end cap is a right-angle piece that will cover the top and side of the edge of the floor. One side is raised, and it caps off the flooring protect it from damage.  An end cap can be used to border off where a floor ends, like a doorway.

Quick-Step Incizio 5-in-1 Molding

Quick-Step revolutionized trim with the Incizio 5-in-1 Molding. This set comes with a slicer that can cut the piece that you need. This piece can be turned into a T-Molding, end cap, hard surface reducer, carpet reducer or a stair nose.

Wall Base

Wall base is a cosmetic piece that will cover the expansion gap. It can be glued or nailed in easily. This trim piece will make the room look complete, professional and elegant. This molding is durable, scratch resistant and made from water resistant glued MDF.

Mohawk SolidTech New Collections-Franklin and Thatcher

SolidTech Colors New Thatcher and Franklin are vinyl planks that have the visuals of hardwood but are easy to clean and are durable. Perfect for busy households.  These new collections are made right here in the United States.

https://flooringmarket.com/collections/mohawk-luxury-vinyl-solidtech-thatcher

https://flooringmarket.com/collections/mohawk-luxury-vinyl-solidtech-franklin

Reducer

Reducer molding trim pieces are used when you have two floors that are slightly different heights. A reducer works well for laminate, wood, vinyl ceramic or low-pile floor. If there is an extreme height difference this will not work, you may need an end cap.